Monroe
OneMonroe
Locations Throughout the Country
ISO 9001:2015
Tel: (877) 740-2007
Fax: (800) 453-9683
Email: sales@askmonroe.com
Website: monroeengineering.com
Print Back
Standard O-Rings are available in 369 sizes as set up by the Aerospace Standard 568 published by the Society of Automotive Engineers. These sizes are designated by dash numbers shown on the 568 DASH Chart and are standardized by imperial dimensions. Standard O-Rings are specified by their inside diameter and cross section width. AS568 is the most commonly used standard in the U.S. for aerospace, automotive and general industrial applications. For more information, please see: Comparison Properties Chart, PTFE Encapsulated O-rings, Material Shelf Life, and O-ring Groove Design Chart. EP is also known as: Eythylene Propylene, EPR, EPDM, EPT, E.

EP is an elastomer which is characterized by wide range of applications and good chemical resistance. Ethylene propylene compounds have good resistance to detergents, alkalis, mild acids, greases, silicone oils, and alcohols.
Unit of Measure

Specifications

Cross Section Width

 N/A 0.275 in

Durometer

 N/A 70

Inside Diameter

 N/A 78.74 mm3.100 in

Cross Section Tolerance +/-

 N/A 0.006 in0.15 mm

Inside Diameter Tolerance +/-

 N/A 0.024 in0.61 mm

Size Reference - AS568

 N/A -414

Warning

 N/A Prop 65 Warning: This product may contain chemicals known to the State of California to cause cancer, and birth defects or other reproductive harm.

O-Ring Industries

 N/A O-rings are used in the military defense and agriculture industries.