DD52-AR-001.00-S-AR F.3/4
Digital Position Indicator - Direct Drive
Installation Instructions for DD51 and DD52
1. Zero set the spindle.
2. Fit the indicator onto the spindle.
3. Mark the machine frame by means of the rear locating pin by rotating the indicator.
4. Pull out the indicator and drill a ø 6mm by 10mm deep hole.
5. Re-fit the zeroed indicator onto the spindle and make sure the rear pin locates into the hole.
6. Tighten the socket head set screw.
Elesa Original Design
Digital Position Indicator - Direct Drive
Installation Instructions for DD51 and DD52
1. Zero set the spindle.
2. Fit the indicator onto the spindle.
3. Mark the machine frame by means of the rear locating pin by rotating the indicator.
4. Pull out the indicator and drill a ø 6mm by 10mm deep hole.
5. Re-fit the zeroed indicator onto the spindle and make sure the rear pin locates into the hole.
6. Tighten the socket head set screw.
Elesa Original Design
Unit of Measure
RPM (Max.) |
N/A 250 |
Type |
N/A AR |
Reading After 1 Revolution |
N/A 001.00 |
Clockwise / Counter clockwise Rotation direction increasing |
N/A Counter Clockwise |
Note |
N/A Please do not use a hammer for installation tip 3. |
Country of Origin |
N/A - |
Warning |
N/A Prop 65 Warning: This product may contain chemicals known to the State of California to cause cancer, and birth defects or other reproductive harm. |
